average cost to install asphalt shingles_Installing Rolled Asphalt Roofing for Durable and Weather-Resistant Protection

Installation of Rolled Asphalt Roofing Rolled asphalt roofing is a popular and economical choice for many homeowners and commercial buildings. Known for its durability and ease of installation, this roofing material is ideally suited for low-slope and flat roofs. In this article, we will explore the basics of rolled asphalt roofing installation, including the necessary tools, materials, and step-by-step instructions. Materials and Tools Needed Before beginning the installation process, it is essential to gather all necessary materials and tools. The primary materials include rolled asphalt roofing (often referred to as rolled roofing), roofing cement, and nails specifically designed for roofing. Essential tools include a utility knife, roofing nailer or hammer, measuring tape, chalk line, and a ladder. Safety equipment such as gloves and goggles should also be on hand to ensure personal safety during installation. Preparation The first step in installing rolled asphalt roofing is to prepare the roof surface. The existing roof should be clean, dry, and free of any debris or sharp objects that could damage the new material. If there are any significant repairs needed, such as replacing damaged decking, this should be done before proceeding. It’s crucial to ensure proper drainage by checking that the roof slopes appropriately away from any roof edges. Laying the First Roll Once the preparation is complete, the next step involves laying the first roll of roofing. Start at the lower edge of the roof, ensuring that the roll is oriented correctly. Typically, the mineral-surfaced side should face upwards. Unroll the roofing material and use the utility knife to cut it to the appropriate length, leaving a few inches of overhang at the edges. rolled asphalt roofing installation Securing the Roof After cutting the first roll to size, it’s time to secure it. Apply a liberal amount of roofing cement under the roll and press it down firmly to ensure good adhesion. Use roofing nails to secure the material along the edges, placing nails approximately 12 inches apart. For extra seal, it’s advisable to apply an additional layer of roofing cement along the top edge of the roll. Overlapping Rolls When laying subsequent rolls, ensure each new roll overlaps the previous one by about 2 to 4 inches. This overlap is essential for preventing water seepage. Repeat the same process of cutting, securing, and nailing each roll until the entire roofing area is covered. Final Touch and Inspection Once all rolls are installed, inspect the roof for any loose sections and reinforce them with additional roofing cement and nails as necessary. Lastly, check for any exposed nails or edges that may need additional sealant to prevent leaks. Conclusion Rolled asphalt roofing is a straightforward and cost-effective solution for many roofing needs. With careful preparation, proper technique, and attention to detail, homeowners can successfully install rolled asphalt roofing, ensuring protection and longevity for their structure. Whether for a shed, garage, or main residence, this roofing option provides durability and efficiency, making it a popular choice in residential roofing projects.